News
How to Control Mold? …Don’t Push the Envelope!
Buildings in the north should not blow and buildings in the south should not suck.
The building envelope is the physical separator between the interior
and the exterior environments of a building. The control function is at
the core of good performance, and in practice focuses, in order of importance,
on rain control, air control, heat control, and vapor control.
Uncontrolled moisture indoors can cause major damage to the building structure,
as well as to furnishings and to finish materials like floors, walls, and
ceilings. Uncontrolled moisture can trigger mold and bacteria growth, which not
only damages the building structure, but can lead to health and performance
problems for building occupants. Mold is usually not a problem indoors
unless there is excess moisture.
Primary
causes of indoor moisture problems in buildings include:
- Inadequate HVAC equipment sizing
- Inadequate fresh air dehumidification
- Inadequate building pressurization/ventilation design/TB
- Use of building materials that are previously wetted
- Poor control of rain and snow resulting in roof and flashing leaks
- Wet or damp construction cavities
- Moisture-laden outdoor air entering the building
- Condensation on cool surfaces
Water also enters construction cavities through a process of moisture migration. Moisture migrates from the warm and humid side of the construction assembly to the cold dry side of the construction assembly. Air pressure differentials can also drive moisture into interior and exterior walls, creating mold-favorable environments, and they can do so in both heating climates and hot, humid climates. In hot, humid climates, even slight negative interior pressures can pull hot outdoor moisture into chilled wall cavities during cooling periods if the building envelope is not properly designed and constructed. Similarly, during heating periods, positive pressures can push warm, moist air from indoors into chilled exterior walls. In either case, this uncontrolled moisture can lead to mold growth that impairs indoor air quality and damages building materials.
Buildings in the north should not blow and buildings in the south should not suck.
For hot, humid climates, a slight positive (Blow) pressurize in the building is recommended, and in northern buildings a slight negative (Suck) pressurize in the building will help. However, in mixed climate areas, using positive or negative pressures can create problems as the weather changes. Ultimately, the most reliable solution is the proper construction of the building envelope.
For a professional assessment of your building envelop and indoor air quality call the building scientist experts at Pure Air Control Services 1-800-422-7873.
About Pure Air Control Services, Inc:
Alan Wozniak founded Pure Air Control Services, Inc. in 1984 as a small mechanical contracting firm. Today, Pure Air Control Services sets the industry standard for indoor environmental quality diagnosis and remediation while servicing more than 500 million square feet of indoor environments in over 10,000 facilities.
Pure Air Control Services nationally performed services include: Building Sciences Evaluation; Building Health Check; an AIHA accredited Environmental Microbiology Laboratory; DIY IAQ Screen Check test kits, Environmental Project Management; and Mold Remediation Services, among other indoor environmental services.
The company’s expanding client roster includes the General Services Administration (GSA); Federal Aviation Administration (FAA), Allstate Insurance; Carrier Air Conditioning; Naval Air Warfare Center, Orlando; and Naval Air Station - King's Bay, Georgia, US Postal Service (USPS) and many other Fortune 500 companies, school boards, and city, state, and county governments, making Pure Air Control Services one of the most reliable IAQ industry leaders.
For more information on Pure Air Control Services, Inc and its indoor environmental IAQ services offering please contact Alan Wozniak at (800) 422-7873 x 802 or visit www.pureaircontrols.com.
More News
IAQ Test Kits (DIY), PURE-Steam Coil Cleaning and PURE-Decon Room Treatment Showcased at the Annual FRACCA Conference
This annual event provides an opportunity for licensed contractors throughout the State of Florida to obtain all 14 state-required hours of continuing education over the course of the two-day event.
Released On: 3/8/2014
Views: 4209
Free Legionella Webinar: Detection & Identification Workshop
Although this type of bacteria was around before1976, more illness from Legionnaires' disease is being detected now. Due to consumer awareness, added research and technological advances in healthcare Legionnaires disease identification is becomi ...
Released On: 3/4/2014
Views: 4027
Why Some High-Performance Buildings Are Failing?
Performance of a building depends on its structured integrity, preventive maintenance, as well as periodical monitoring of the environmental conditions essential for its functionality.
Released On: 2/19/2014
Views: 4053
Legionnaire’s – What You Should Know About The Potential Deadly Bacteria
According to Building Operating Management magazine, expert Victor Yu, MD, Professor of Medicine, University of Pittsburgh; Chief, Infectious Disease Section, VA Medical Center, Pittsburgh, PA, disclosed that “Up to 70% of all buildings greater t ...
Released On: 2/18/2014
Views: 3619
Managing of Indoor Environments: Problems and Solutions - IEQ WEBINAR
Released On: 1/22/2014
Views: 3509
Save Energy and Improve Indoor Air Quality (IAQ) with PURE-Steam Deep Coil Cleaning
High efficiency coils are extremely susceptible to blockage from dust accumulation because once lodged deeply within the fins bacteria and mold may initiate growth, which not only compounds the blockage problems but also gives rise to excessive o ...
Released On: 1/8/2014
Views: 6285
January is National Radon Action Month
Exposure to radon is the second leading cause of lung cancer after smoking. Radon is an odorless, tasteless and invisible gas produced by the decay of naturally occurring uranium in soil and water.
Released On: 1/8/2014
Views: 3959
Why indoor air quality is important to all of us?
World Health Organization (WHO Guidelines for Indoor Air Quality, 2009) concluded that the most important effect is increased prevalence of respiratory symptoms, allergies and asthma, as well as perturbation of the immunological systems
Released On: 12/31/2013
Views: 3982
Pure Air Control Services Launches New Interactive Website
The website is a true indoor environmental resource for the private and public sector including consumers, educational facilities e.g. schools, universities, along with city, county state and federal governments, healthcare and the public sector.
Released On: 12/20/2013
Views: 3020
Pure Air Control Services Awarded Certification from Doctor Trusted
“We are very proud to have been given the opportunity to display that we are a Doctor Trusted recipient. We will continue as always to help provide our customers with a great products and services,” stated Dr. Rajiv Sahay, environmental analytica ...
Released On: 12/11/2013
Views: 3950
IndoorAirTest.com Receives Seal of Approval by Doctor Trusted
IndoorAirtest.com is very proud to have a Doctor Trusted seal of approval displayed on our website, giving our customers more confidence when shopping with us.
Released On: 12/4/2013
Views: 4366
PURE-Decon/Sanosil, Reduces Sick Days Caused by Infection
Released On: 10/2/2013
Views: 3304
Controlling Asthma & Allergy Triggers Through Source Identification
The assessment of allergens in a house dust sample is an essential step for allergen-avoidance and provides information essential for allergen-reducing measures, in addition to managing the indoor environment from a health and hygiene point of view
Released On: 9/18/2013
Views: 5389
Hospitals Get a “Clean Bill of Health” with Innovative IAQ/Energy Solutions
Healthcare-associated infections (HAIs) are infections that patients acquire during the course of receiving healthcare treatment for other conditions.
Released On: 7/31/2013
Views: 4425
How Safe is Formaldehyde in our Buildings and Homes?
Released On: 7/17/2013
Views: 4668
Commercial Energy Solutions Seminar July 26, 2013
Released On: 7/11/2013
Views: 4736
Health Risks Associated With Indoor Microbes
Some common and frequently reported microbes of the indoor environment include, but are not limited to, viruses, bacteria, mycoplasma, mold (fungi), yeast, protozoa, etc.
Released On: 6/26/2013
Views: 5911
Aspergillosis: A Cause for Indoor Concerns?
In indoor environments, this fungus can be transported from outside or may propagate on building materials such as cellulose rich sheet rocks, etc. and can generally be isolated from floors, carpets, mattress dust, Heating Ventilation Air Conditi ...
Released On: 6/19/2013
Views: 10470
Map
Pure Air Control, Services, Inc.
Get DirectionsPure Air Control, Services, Inc.
-
4911 Creekside Drive
Clearwater, Florida 33760
United States - 1 (800) 422-7873
